Use Your Own Estimates.
Use our Turb-O-Web calculator.
This calculator will give you a guide as to how the Turb-O-Web System can help you – Based on your figures!
Enter Your Own Values
- Just enter into the top box [Box 1] your estimation of the percentage of webs in your jobs by piece count.
(Change the 45 to your number.)
2. Then enter into the next box [Box 2] your estimation of the percentage of these webs which could be replaced by precut Turb-O-Webs. A guide for this is in the 55-65% range.
(Change the 55 to your number.)
Play with a few different percentages yourself and you’ll see the results immediately.
For a full description and an example of using this calculator please go to the bottom of this page.
Tips On Using This Calculator.
Our Default settings are as follows:-
[Box 1] 45%. For the example we have estimated that 45% of the pieces to be cut as listed on the cutting sheet/s are webs.Change the 45 to your number.
[Box 2] 55% . Also, we have estimated that 55% of all webs in the job/s are able to be replaced by precut Turb-O-Webs.Change the 55 to your number.
Change tour figures to your estimations.
From these inputs we get the following outputs.
[Box 3] The number of precut Turb-O-Webs that can be added to 100 parts cut by the plant. (33 in our example).
[Box 4] Confirms the percantage increase in available cut truss parts for assembly. (33 in our example).
[Box 5] and [Box 6] Details that without Turb-O-Webs the plant’s cutting profile between “chords and other parts” and webs respectively. (55% and 45% respectively in our example).
[Box 7] and [Box 8] Sets out the cutting profile after Turb-O-Webs are introduced. In our example the chords and other parts now represent 73% of the plant’s cutting and the webs are only 27%.
For some plants cutting chords is easier/ faster than cutting webs, so this change could improve flow through the saws.
[Box 9] shows the percentage of the saws output given in [Box 7] and [Box 8] is supplemented by precut Turb-O-Webs. 33% in our example.
Go ahead and enter your own numbers and do a few “What If..” comparisons.
Call me if you have problems / questions – John Griffith 0418 488 935
Contact Turboweb Australia for more information on the benefits and use of pre-cut Turb-O-Webs.
Turboweb Australia Pty Ltd.
PO Box 442
Swansea NSW 2281
0418 488 935
Pre-Cut Turb-O-Webs are manufactured using the Patented Multi-Faceted End.
Patent in Australia No. 2004202948, MULTI-FACETED END FOR ROOF TRUSS WEB.
Patent in Australia No. 2004216626, METHOD OF CUTTING SEGMENTED-END TRUSS WEB
Icons from flaticon.com
© 2017 All Rights Reserved Turboweb Australia Pty Ltd.